I am installing H&R OE springs on my 2006 Wrx non sti is the handling better, is there any abnormal tire wear

How much you dropping the car, if you are dropping less than 1.5 inches you be ok and no tire wear will occur. Check out some subaru forums that will help you out with subaru question better than over here in .

try nasioc.com, rs25.com
scoobymods.com
i-club.com

They really help you out with your subaru needs. Hope l help out on something have a good day. Your fellow Subaru owner, l have Modded 2003 Subaru Forester.

if there is any abnormal tire wear, then you need to get the toe adjusted. if your lowering your wrx for better cornering, then try not to adjust the camber too much.

What was said before is correct.if u r dropping it with those H&R Springs u should be fine.

BUT, u need to make sure that u get an alignment done after the fact. This is usually about $100 to $150 so u should probably do some other mods that you've been thinking about before getting it aligned so that u only pay for it once.

When changing the springs u have to take off the strut which requires u to take off the camber bolt. Which is why u need to get everything reset once you're done.

The handling will be better of course as long as the springs r the correct stiffness for ur car & ur setup. Oh & of course it lowers ur center of gravity which helps a lot.